Victron Energy 50A Buck-Boost DC-DC Converter ORI303050000

Victron Energy - 50A Buck-Boost DC/DC converter - ORI303050000

DC-DC Converter for charging a 12/24V service battery in vehicles with an intelligent dynamo.

The 50A Buck-Boost DC-DC Converter is a DC-DC converter for charging a 12/24V service battery in vehicles with an intelligent dynamo. Since, when the engine is running, these dynamos (powered by the on-board electronics of Euro 5 and 6 engines) do not always emit the correct charging current, a DC DC converter is essential for charging the service battery properly.

DC-DC Converter for charging a 12V or 24V service battery in vehicles with a smart alternator (regenerative braking, Euro 5 and Euro 6 engines)

The Buck-Boost DC-DC Converter is a DC-DC Converter for charging a 12V or 24V service battery in vehicles with a smart alternator. The converter will charge the auxiliary battery with a pre-set charge voltage, eliminating high voltages (e.g. Mercedes: 15,4V) and low voltages.

Engine running detection system

Deep discharge of the vehicle's starting battery is avoided by a built-in "engine running" detection system. Instead of this detection system, the converter can also be activated by means of a programmable input (D+, CAN bus or (+)15 connection).

Fully programmable

The converter can be fully programmed by means of a simple and user-friendly PC application. (USB type A male to USB type B male cable needed)

One product for 12V, 24V and 12/24V systems

The converter can be programmed to charge a 12V or a 24V auxiliary battery from either a 12V or a 24V alternator and starter battery.

Charge current and input current limiter

The output current is determined by the following factors:

• The maximum charge current setting.
• The maximum input current setting.
• The maximum operating temperature limit of the converter.

Input status indication (LED)

• Green: converter on.
• Yellow: input voltage below threshold, converter off.
• Red: over temperature, converter off.
• Blue, quick flash: engine running, converter will start after preset delay.
• Blue, slow flash: the converter is OFF and activation is blocked due to low input voltage.

Output status indication (LED)

• Green: converter off, battery voltage normal.
• Yellow: converter off, battery voltage low.
• Red: converter off, battery discharged or not connected.
• Purple: converter on.