This website uses cookies, which are necessary for the technical operation of the website and are always set. Other cookies, which increase the comfort when using this website, are used for direct advertising or to facilitate interaction with other websites and social networks, are only set with your consent.
Used for cleaning and disinfecting air conditioning systems in passenger motor vehicles and commercial vehicles. The product can also be used for domestic air conditioning systems.
Special cleaner for removing mold and bacteria simply and effectively from A/C systems without dismantling. Leaves behind a pleasantly fresh fragrance after cleaning. All service recommendations released by vehicle manufacturers regarding the cleaning of air conditioning systems are to be followed. Use biocides safely. Always read the label and product information before use.
Packed in portions: One pack will treat one vehicle or one air conditioning system. If the manufacturer of the air conditioning system provides a cleaning service recommendation, this recommendation must be observed. If no model-specific instructions are available from the passenger car manufacturer, follow the LIQUI MOLY recommendation for application. Spray the cleaning fluid directly on the surface of the evaporator (if possible) for commercial vehicle, bus and home A/C systems.
LIQUI MOLY recommended use:
Make sure the window is open during the cleaning process. Avoid inhaling the vapors during cleaning.
Check to make sure that the condensation water drainage openings are not blocked
Dry the surface of the evaporator for 10 minutes with the engine running using the following heater and blower settings: Switch off the air conditioning unit and set to air circulation. Set the air distribution switch to footwell. Turn the temperature regulator and blower selector to maximum.
Cleaning the air conditioning system:
Insert the probe of the cleaner toward the evaporator (center of the vehicle).
Actuate the cleaner and move the spray probe carefully back and forth to flush out and clean the evaporator thoroughly.
Allow 15 - 20 minutes for the cleaning fluid to take effect.
Dry the surface of the evaporator for 10 minutes with the heater and blower at the same setting as prior to cleaning.
Replace the dust and pollen filter.
Note: Any cleaner which is spilled must be wiped up using a damp cloth and water.
